tension reinforcement

Based on the relation between cracking moment and yield moment of beam end section, the functions of minimum ratios of reinforcement for tension reinforcement of the beam end in positive and negative moment areas in ensuring seismic behavior of the structure are studied in this paper.

本文以梁端截面的开裂弯矩与屈服弯矩的关系为基础，分析了梁端正、负弯矩受拉钢筋最小配筋率在保证框架抗震性能中的作用。

In the design of reinforced earth retaining wall structures, the calculation of max tension force in the reinforcement is one of important contents.

筋材的设计计算是加筋土挡墙设计中重要组成部分之一。

Using of economic tension reinforcement ratio in designing of suffer curved construction

经济配筋率在受弯构件截面设计中的应用

A general equation for determining the neutral axis in partially prestressed concrete T or I Section beams with tension and compression reinforcement is presented in this paper.

本文导出了最一般的双筋T形或工形截面部分预应力砼梁开裂后截面中和轴高度的基本方程，并对其作了分析讨论。

Simultaneously, the tension of reinforcement can reduce the lateral displacements and improve the stability of the embankment.

同时，水平加筋体的抗拉作用可减小路堤的侧向变形，提高路堤稳定性。

Furthermore, frequency of concrete beam reinforced by external prestress was studied with the consideration of various factors ( different steering structure, tension method, prestressed reinforcement curve form).

考虑各种因素（不同转向结构、张拉方式和力筋曲线形式下）后，对体外预应力加固混凝土梁的频率进行研究。

Significance and Method of Tension Reinforcement Limit Strain State Control in Designing Reinforced Concrete Bridges and Culverts

钢筋混凝土桥涵设计中引入受拉钢筋极限应变控制的意义与方法

This composite foundation transfers the loads to the rigid grid structure through bedding cushion and tension reinforcement net firstly, the load then were passed to deep clay by piles.

这种复合地基通过过渡垫层及张拉网或张拉筋把荷载传递到刚性网格结构上，再通过桩把荷载传递深层土体中。

Centrifugal model test study on tension of CAT reinforcement in reinforced earth retaining wall of three steps

三级加筋土挡墙CAT拉筋的离心模型试验研究

The tension reinforcement ratio and the aspect ratio of the loading area are two important factors that influence the punching capacity of concrete slabs.

纵筋率及冲切加载面边长比是影响混凝土板受冲切承载力的重要因素。

The application of external prestress vertical tension method in bridge reinforcement

谈体外预应力竖向张拉法在大桥加固中的应用

According to the economic tension reinforcement ratio, for quickly, simply, practically designing of suffer curved construction.

本文根据经济配筋率，对受弯构件正截面进行快速、简便、实用的截面设计。

Also, there are tension stresses in web at mid-span, and the maximum value reaches 0.91 MPa. Therefore, vertical tension reinforcement should be arranged to ensure the safety of against cracking.

跨中截面腹板出现拉应力，最大可达0.91MPa，设计中应考虑设置一定的竖向抗拉钢筋，防止裂缝产生。

Normal Section Bearing Capacity of Rectangular Concrete Beam with Tension Reinforcement only under Inclined Bending

钢筋混凝土单筋梁的斜向受弯正截面承载力

Discussion on anchorage length of tension reinforcement in concrete structure design

浅析混凝土结构设计中受拉钢筋的锚固长度

By analyzing the influence on the displacement among every factors, the approach proposes that the downward anchor can increase its tension and reinforcement, but it also can reduce the horizontal displacement of the top end of the pile after the ancher is pre_tensioned.

通过分析水平位移的各个影响因素对位移的作用，指出锚杆位置下移会增加锚杆的拉力并进而加大其配筋，但可以减小桩顶在锚杆张拉锚固后的水平位移变形。